Çok fonksiyonlu kamera kalibrasyonu
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Bu fonksiyon, ön camdaki çok fonksiyonlu kamerayı kalibre etmek için kullanılır.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
Ön cam değiştirildikten sonra.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Eğer çok fonksiyonlu kamera kalibre edilmemişse, göstergede bir uyarı mesajı gösterilecektir.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Aracı düz ve eğimsiz bir yüzeyde durdurunuz.
Lastikler dumduz olmalidir.
Optik ünite için bulunan ön cam alanı temiz ve hasarsız olmalıdır.
Kamera görüş alanı net olmalıdır.
Akü voltajı 12 Volt üzerinde olmalıdır.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Test koşulları sağlandığında fonksiyonu başlatınız.
Kalibrasyon gerçekleştirilir ve sonuçlar sunulur.
İşlem başarısız olursa test koşullarını kontrol ediniz ve her türlü hatayı onarınız.