This function describes how to bleed the clutch hydraulics.
Po výměně převodovky, modulu spojky s řadičem MTA nebo součástí hydraulického systému nebo po otevření nebo vypuštění hydraulického potrubí musí být odvzdušněna hydraulika spojky.
Poznámka:
Za účelem zajištění funkce spojky by mělo být odvzdušnění prováděno pouze s diagnostickým nástrojem a nástrojem pro odvzdušnění brzd. Manuální odvzdušnění není povoleno. Před použitím nástroje pro odvzdušnění brzd se prosím seznamte s instrukcemi výrobce.
Podmínky testu:
Zapalování zap., motor vyp. - motor se nastartuje během postupu.
Parkovací brzda je zatažena.
Převodovka v neutrálu.
Postup:
Install the brake bleeding tool (Observe the manufacture's instructions). Enlist the support of TIS (Technical information) from Opel's website: www.gme-infotech.com
Bleed the hydraulic clutch system (step 1): Open the bleed nipple (Make sure that the bleed nipple is open at least 180° to reach the correct bleeding).
Allow the liquid to drain from the bleed nipple until it is clear and without bubbles, then close the bleed nipple.
Empty the bleed reservoir (if needed).
Bleed the hydraulic clutch system with the diagnostic tool (step 2): 2 mechanics is required.
Enter the program function "Component activation" and select clutch activation.
Open the bleed nipple.
Activate the clutch activation 15 times (On, then Off) in intervals of one second.
Allow the liquid to drain from the bleed nipple until it is clear and without bubbles, then close the bleed nipple.
Empty the bleed reservoir (if needed).
Bleed the hydraulic clutch system with the diagnostic tool (step 3): 2 mechanics is required.
Activate the clutch activation (On) to pressurize the clutch hydraulic system, immediately open the bleed nipple, then close the bleed nipple.
Deactivate the clutch activation (Off) to bleed the pressure in the clutch hydraulic system.
Repeat step 3 for at least 10 minutes until the liquid is clear and without bubbles.
Empty the bleed reservoir (if needed).
Do not engage any gears yet.
Start the engine and let it idle for 10 seconds, then stop the engine.
Repeat step 1 of the bleeding procedure.
Repeat step 2 of the bleeding procedure.
Repeat step 3 of the bleeding procedure.
Remove the brake bleeding tool. Enlist the support of TIS (Technical information) from Opel's website: www.gme-infotech.com
Perform the programming of the clutch hydraulic system.
Pokud dojde k chybě funkce, zkontrolujte podmínky testu a odstraňte případné poruchy.