Multifunction camera calibration

To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
This function is used to calibrate the multifunction camera in the windshield.
The function may need to be performed after the following repairs or events:
Note:
If the multifunction camera isn't calibrated, a warning message will be shown in the instrument.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Test conditions:
Place the calibration help according to the picture and text below:
Procedure:
  1. Start the function when the test conditions are fulfilled.
  2. The calibration is performed and the result is presented.
  3. If the function fails, check the test conditions and repair any faults.