Reset of the calibration values and the learning values

This function is used to reset the calibration values, the learning values and the CVT liquid's wear counter after replacing the transmission assembly. After the reset, a table shows the values before and after the reset. See Nissan's workshop manual for further information about the table values.
Note:
This function doesn't need to be performed if only the transmission control unit has been replaced.
NOTICE: Do not start the engine!
Test conditions:
Procedure:
  1. Start the function.
  2. Gear selector in position R.
  3. Press down accelerator pedal all the way.
  4. Turn off the ignition for 10 seconds.
  5. Turn on the ignition again. Press "OK" to continue.
  6. A table is shown.
  7. The function is done.
  8. Put the gear selector into position "P" and make sure that "P" appears in the display (may take up to 5 seconds). If "P" doesn't appear, check the following: