VSA sensor learning of neutral position

This function is a manual function for learning the neutral position of the VSA sensor.
Note:
This is a manual function for learning the neutral position of the VSA sensor, follow the instructions in the help file and the program carefully.
It will light up a new window in the instrument "SCS mode"!!
Test conditions:
Procedure:
  1. Select the function "VSA (Vehicle Stability Assist) sensor neutral position memorization" in the list.
  2. Start the function and follow the instructions in the program.
  3. When you for the second time are requested to turn off the ignition and gets the instruction "Execute driving according to the help file to complete the calibration", press "OK" to start the manual function.
  4. After the ignition has been turned on, the ABS lamp lights for 2 seconds and then goes out.
  5. After the ABS lamp has gone out, immediately press the VSA Off button and release it again within 0,5 seconds.
  6. The ABS lamp will light up again, then press the VSA OFF button again and release it within 0,5 seconds.
  7. The VSA (Vehicle Stability Assist) lamp will flash twice and then light up again.
  8. When the ABS lamp, VSA (Vehicle Stability Assist) lamp and VSA (Vehicle Stability Assist) activation lamp goes out then is the manual function complete. If they do not, turn off the ignition again and repeat from step 4.
  9. Press "OK" when the function is complete.
  10. A dialogue box instructs "Turn off ignition".
  11. A dialogue box instructs "Turn on the ignition".
  12. The function is done.