Reset service message

This function is used to reset the service message.
Mini CBS (Condition Based Service) reset is a service system based on driving distance, time, and driving conditions. Using these parameters, the service condition (service scope) is calculated and shown on the vehicle's information display. Service conditions can also be read out with the diagnostics instrument, either as data list parameters or during service reset for each specific system. When the service reset is finished, availability factor 100% is shown. Then this is counted down to 0%. The service counter shows the number of performed service resets.
There are 5 different points stored in the vehicle's different control units.
CBS Service scope
Interval
Start value Distance (km)
Calculated time interval (months)
Engine oil: Gasoline/Diesel engines
Flexible
25000 / 30000
24
Front brake pads
Flexible
40000

Rear brake pads
Flexible
50000

Vehicle check: Gasoline/Diesel engines
Fixed interval
50000 / 60000
48
Brake fluid
Fixed interval

24
Data lists and basic adjustments show:
Note:
Test conditions:
If the reset is not feasible, try to start the engine, but only in these cases.
Procedure:
  1. Select function "Resetting service message" for current service and press "OK".
  2. A dialogue box shows current service status for selected CBS-reset.
  3. Confirm with "Yes" to perform the service reset.
  4. A dialogue box informs that the original value can not be recovered after a reset. Confirm with "Yes" to perform the reset.
  5. A dialogue box shows the new values for CBS-reset.
  6. Press "OK" to exit the function.