This function is used to program the new camera height for the lane departure warning system.
Note:
The minimum value that can be programmed is 150cm and the maximum value is 300cm. To obtain the value, measure from the ground to the camera lens and enter the value in centimeters.
Test conditions:
The vehicle must stand on level ground.
Normal driving level.
Cabin locks in the locked position.
Correct tire pressure.
Ignition on, engine off.
Transmission in neutral.
Procedure:
Start the function.
The current parameter value is displayed.
Proceed for programming the new value.
Enter the distance from the ground to the camera lens in centimeters.
Programming is performed.
The new programmed parameter value is displayed.
Function done.
If the function fails, check the test conditions and repair any faults.