This function is used to program the clutch hydraulic system and must be performed after work on the clutch hydraulics.
Примечание:
Make sure that the hydraulic clutch is fully bleed before performing this function.
Условия тестирования:
Зажигание включено, двигатель выключен - двигатель запускается во время процедуры.
Стояночный тормоз включен.
Трансмиссия в нейтральном положении.
Bleeding of the clutch has been performed.
Процедура:
Запустите функцию и следуйте инструкциям в программе.
Do not engage any gears.
Verify the speed of the transmission input shaft in the data list. The speed of the transmission input shaft should remain at 0 rpm for about 30 seconds when the neutral gear is angaged.
Функция завершена.
Если функция завершилась неудачно, проверьте условия испытания и исправьте возможные дефекты.