Программирование высоты камеры

Эта функция используется для программирования высоты новой камеры для системы предупреждения о выходе за пределы полосы движения.
If the camera, windshield or the bracket has been replaced, the camera must be programmed.
Примечание:
To perform the calibration you must have equipment, Scania No. 2200024 (target) and 2245478 (measuring equipment), for the camera to know its correct position in relation to the ground. It is important that the target has right angles and flat surface in relation to the vehicle. There are information about the calibration in Scania Multi 16-15, E101.
Условия тестирования:
Процедура:
  1. Запустите функцию.
  2. Появится диалоговое окно с условиями испытания, проверьте их и нажмите "OK".
  3. Place the target in front of the camera lens, 1,7m (-/+5 cm) in front of the vehicle and press "OK".
  4. Move the target to 2,7m (-/+5 cm) in front of the vehicle and press "OK".
  5. Check, in the dialogue box, that the value of the height between the camera lens center and the ground is correct and press "OK".
  6. Функция выполнена.