Калибровка многофункциональной камеры
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Эта функция используется для калибровки многофункциональной камеры на ветровом стекле.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
После замены ветрового стекла.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Если многофункциональная камера не откалибрована, на приборной панели отображается предупредительное сообщение.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Установите автомобиль на ровной горизонтальной площадке.
Колеса повернуты прямо вперед.
Ветровое стекло чистое и не повреждено в области оптического блока.
Поле обзора камеры должно быть свободным.
Напряжение аккумулятора выше 12 В.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Запустите функцию после выполнения условий проверки.
Выполняется калибровка, и отображаются ее результаты.
Если функция завершилась неудачно, проверьте условия испытания и исправьте возможные дефекты.