Learning function for the gearbox

This function is used to perform a standard adjustment and adaptation after replacing the gearbox/clutch.
The function must be run following replacement or repair of the following:
Note:
Make sure that the hydraulic clutch is fully bleed before performing this function.
This function must only be performed once!
Test conditions:
Procedure:
  1. Start the function and follow the instructions in the program.
  2. After completed function should the clutch progressivity be learned.
  3. Start the engine and drive the car until the clutch progressivity is OK.
  4. Stop the engine, turn off the ignition and wait for about 60 seconds.
  5. Activaţi contactul de aprindere.
  6. Funcţia este executată.
În cazul în care funcţionarea funcţiei eşuează, verificaţi condiţiile de test şi reparaţi orice posibile defecţiuni.