This function is used to program the clutch hydraulic system and must be performed after work on the clutch hydraulics.
Note:
Make sure that the hydraulic clutch is fully bleed before performing this function.
Test conditions:
Aorindere pornită, motor oprit - motorul este pornit în timpul procedurii.
Parking brake applied.
Transmisie în poziţie neutră.
Bleeding of the clutch has been performed.
Procedure:
Start the function and follow the instructions in the program.
Do not engage any gears.
Verify the speed of the transmission input shaft in the data list. The speed of the transmission input shaft should remain at 0 rpm for about 30 seconds when the neutral gear is angaged.
Funcţia este executată.
În cazul în care funcţionarea funcţiei eşuează, verificaţi condiţiile de test şi reparaţi orice posibile defecţiuni.