Multifunction camera calibration
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
This function is used to calibrate the multifunction camera in the windshield.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
După schimbarea parbrizului.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
If the multifunction camera isn't calibrated, a warning message will be shown in the instrument.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Position the car on a flat and level surface.
Tires pointed straight ahead.
Parbriz curat şi nedeteriorat în zona unităţii optice.
The camera field of view must be clear.
Battery voltage min 12 V.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Start the function when the test conditions are fulfilled.
The calibration is performed and the result is presented.
Dacă funcţia eşuează, verificaţi condiţiile de testare şi reparaţi orice defecţiuni.