Bleeding the brake system

This basic setting is used when bleeding antilock brake systems (ABS). This is only needed when at least one of the chambers in the brake fluid reservoir has been emptied, or when changing the brake fluid.
Note:
The bleeding should be done in a sequence of several steps by the user. Manual brake bleeding should be performed before and after this function.
Test prerequisites:
Procedure:
  1. Manual bleeding done before.
  2. Connect venting bottles on both front brake calipers.
  3. Open both bleed nipples.
  4. Slowly press down the brake pedal and wait 2 seconds.
  5. Release brakepedal.
  6. Repeat until air bubbles disappear.
  7. Close the air nipples.
  8. Repeat the same procedure on the rear brake calipers from step 2.
  9. Start the function and follow the instructions in the program.
  10. A dialog box present "Operation succeeded".
  11. Disconnect the air bleeding equipment from the brake fluid container.
  12. Manual bleeding should now be performed.
  13. Connect venting bottle on the left front brake caliper.
  14. Depress and hold the brake pedal.
  15. Open the bleed nippel and close it again.
  16. Release brakepedal.
  17. Repeat the procedure from step 14 until the air bubbles disappear.
  18. Repaet the procedure from step 13 in the following order: right front, right rear and left rear.
  19. Fill the brake fluid reservoir to max. level.
  20. Funcţia este executată.