Learning of wheel sensor ID

This function is used to learn the vehicle's wheel sensors via diagnosis.

The learning must be done in the following cases:

Note:

When changing wheels, the vehicle must be stationary for 8 minutes before the tire pressure control is learned.

The replaced wheels must be equipped with the correct wheel electronic units.

Test conditions:

Ignition on.
The tire pressure should be set with cold tires according to the instruction manual. (Learning is only possible when the pressure in all wheels are at least 1.6 bar. Is the tire pressure below this limit in one of the wheels, a Check Control message is immediately displayed.)

Procedure:

Începeţi funcţia.
When the function is complete, disconnect the diagnostic equipment.
A driving should now be performed. The vehicle must be driven for 10 minutes with a speed of at least 30 km/h.
The learning is now completed.