This function should be used when the gearbox control unit or the valves has been replaced. The function will learn the new offset values for the gearbox hydraulic valves.
Note:
The PRNDL indicator should not be flashing, if so, turn OFF the ignition and wait for 30 seconds until the control unit has gone into sleep mode. Then turn ON the ignition again.
Preconditions for the test:
Erase any fault codes.
Frâna de parcare aplicată.
Pedala de frână a fost apăsată.
Engine started.
Sistem de climatizare oprit.
Transmission oil temperature above 30°C.
Procedure:
Start the function and follow the instructions in the program.
În cazul în care funcţionarea funcţiei eşuează, verificaţi condiţiile de test şi reparaţi orice posibile defecţiuni.