Preparation and adjustment of the position sensor for the variable valve event lift system

This function is used to adjust the position sensor for the variable valve event lift system. First a preparation of the position sensor will be done using the computer and then might a manual adjustment be performed. After the entire function is completed, the function "Idle air volume learning" must be performed.
Note:
This function must only be run when the actuator for the variable valve event lift system is replaced.
Test conditions:
Procedure:
  1. Începeţi funcţia.
  2. Once the preparation is complete, the manual adjustment begins. Instructions is displayed through the entire procedure.
  3. Loosen the 2 screws for the position sensor and adjust until the value is OK.
  4. Tighten the screws.
  5. Dezactivaţi contactul de aprindere timp de 10 secunde.
  6. Start the engine and allow it to reach normal operating temperature.
  7. Dezactivaţi contactul de aprindere şi aşteptaţi 10 secunde înainte de a activa din nou contactul de aprindere.
  8. Funcţia este executată.
  9. Start the function "Idle air volume learning".