Level sensor, calibration
This function is used to calibrate the air suspension.
Calibration of level sensors should be performed when:
The control unit has been replaced.
Level sensors has been repaired or replaced.
Autovehiculul se va mişca în sus şi în jos când suspensia pneumatică este calibrată. Prin urmare, este foarte important ca nicio persoană să nu rămână sau niciun echipament să nu fie lăsat în zona din jurul autovehiculului sau dedesubtul acestuia, pentru a preveni daunele sau vătămările.
The calibration is performed by setting the vehicle in the correct driving level with the buttons in the function. When the vehicle is correctly set, the level sensor can verify that they are within the tolerance level.
The calibrated values must be within 2,40 V - 2,60 V.
Maximum difference between the sensor values +/- 0,05 V.
Always adjust the height of the air suspension in the same way: From rear to front axle.
Condiţii de derulare test:
Before starting the function, make sure that the vehicle is in the following position:
Constant air supply in the system.
Parking brake not applied.
Autovehiculul trebuie să staţioneze pe sol nivelat.
Make sure that the vehicle can not start to roll.
Set the vehicle in the correct level by activating the valves.
Read out the sensors that they are within the tolerance (Sensors outside the tolerance level is changed by adjusting the level sensor arm to the correct tolerance level).
Chose "OK" to start calibration.
If the calibration failed, check the values of the sensors and rectify any incorrect values.