Initiation flywheel sensor

This function is used to initiate the sensor for the flywheel top dead center.
Note:
Only perform this function if the sensor has been replaced. After the function has been completed, the following procedure must be performed during driving:
Decelerate, with all the pedals released, between 4000 rpm to 1200 rpm on the third gear. Then check that the status of the flywheel programming is "Done". If the status is "Not done", the programming needs to be performed again.
Condiţii de testare:
Procedure:
  1. Începeţi funcţia.
  2. After completed function, perform the procedure as described above.