Level calibration air suspension
This function is used to calibrate the air suspension.
Calibration of level sensors should be performed when:
The control unit has been replaced.
Level sensors has been repaired or replaced.
Autovehiculul se va mişca în sus şi în jos când suspensia pneumatică este calibrată. Prin urmare, este foarte important ca nicio persoană să nu rămână sau niciun echipament să nu fie lăsat în zona din jurul autovehiculului sau dedesubtul acestuia, pentru a preveni daunele sau vătămările.
Condiţii de derulare test:
Before starting the function, make sure that the vehicle is in the following position:
Constant air supply in the system.
Autovehiculul trebuie să staţioneze pe sol nivelat.
The vehicle must be unladen.
The calibration is performed by using raise and lower buttons in the dialogue box. Before the calibration is performed a spacer must be placed on each side rear, between the axle and frame. The spacers size depends on vehicle type.
35 C - 40 C - 45 C - 50 C =110 mm.
Select the calibration function.
A dialogue box with level sensors is shown.
Select "Rear axle" and then press on the "Up" button to raise the chassis.
Plasaţi distanţierele aproape de fiecare burduf.
Coborâţi autovehiculul pe distanţiere utilizând butoanele din program.
Chose "OK" to start calibration.
Select "Rear axle" and then press on the "Up" button to raise the chassis.
If the calibration failed, check the test conditions and try again.