Multifunction camera calibration
This function is used to calibrate the multifunction camera in the windshield.
This may need to be done after a window replacement or camera replacement.
If the multifunction camera isn't calibrated, a warning message will be shown in the instrument.
If the calibration is canceled, a fault code is stored in the fault memory.
The calibration aid can be printed out using the attached document. Measure that the printed scale matches the specified value.
The calibration aid can also be ordered from the OEM manufacturer (ROMESS part number: 09840-10).
Position the car on a flat and level surface.
The vehicle must be in normal level.
The headlamps must be turned off.
Tires pointed straight ahead.
Parbriz curat şi nedeteriorat în zona unităţii optice.
The camera field of view must be clear.
Make shure all the doors, the hood and the luggage compartment lid are closed.
Correctly positioned calibration aid.
Position the calibration aid as follows:
Position the calibration aid on a rack in front of the center of the vehicle.
Mount the calibration aid perpendicular and horizontal in front of the center of the vehicle.
At chassis 166: Measure that the center of the calibration aid is 1000 mm in front of the center of the bumper.
Other chassis: Measure that the center of the calibration aid is 0 - 300 mm in front of the center of the bumper.
Measure that the center of the calibration aid is 1275 mm above the floor.
Start the function when the test conditions are fulfilled.
Select the current chassis from the presented list.
If required: Enter the distance between the bumper and the calibration aid (0 - 300 mm).
Select whether you want to perform or cancel the calibration.
The calibration is performed and the result is presented.
Dacă funcţia eşuează, verificaţi condiţiile de testare şi reparaţi orice defecţiuni.