This function is used to program the clutch hydraulic system and must be performed after work on the clutch hydraulics.
Merk:
Make sure that the hydraulic clutch is fully bleed before performing this function.
Testforutsetninger:
Tenning på, motor av - motoren startes under prosedyren.
Håndbrems på.
Girkasse i nøytral.
Bleeding of the clutch has been performed.
Utførelse:
Start funksjonen og følg instruksjonene i programmer.
Do not engage any gears.
Verify the speed of the transmission input shaft in the data list. The speed of the transmission input shaft should remain at 0 rpm for about 30 seconds when the neutral gear is angaged.
Funksjonen er ferdig.
Hvis funksjonen mislykkes, må testforholdene sjekkes og eventuelle feil rettes.