Radar calibration
This function is used to calibrate the radar, by driving in traffic.
Note:
The vehicle must be driven on the road in more than 50 km/h, after the start of this calibration.
The calibration takes up to 10 minutes.
Test conditions:
Vehicle stationary.
Ignition on.
Parking brake applied.
No current fault codes in the system.
Procedure:
Start the function.
Follow the instructions in the program.
Start the calibration and drive the vehicle on the road.
A fault message is displayed in the instrument.
Drive the vehicle on the road until the warning, in the instrument, turns off.
Calibration is complete.
Read out fault codes from the system.
The function is done.
If the function fails, check the test conditions and repair any faults.