Kalibrering av multifunksjonskamera
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Denne funksjonen brukes til å kalibrere multifunksjonskameraet i frontruten.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
Etter endring av frontruten.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Hvis multifunksjonskameraet ikke kalibreres, vil en advarsel vises i instrumentet.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Plasser bilen på et plant og vannrett underlag.
Frontrute ren og uskadet i området for den optiske enheten.
Kameraets synsfelt må være klart.
Batterispenning over 12 volt.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Start funksjonen når testbetingelsene er oppfylt.
Kalibreringen utføres, og resultatet oppgis.
Hvis funksjonen mislykkes, må testforholdene sjekkes og eventuelle feil rettes.