This function is used to program the clutch hydraulic system and must be performed after work on the clutch hydraulics.
Opmerking:
Make sure that the hydraulic clutch is fully bleed before performing this function.
Test condities:
Contact aan, motor uit - de motor wordt tijdens de procedure gestart.
Parkeerrem toegepast.
Neutrale transmissie.
Bleeding of the clutch has been performed.
Procedure:
Start de functie en volg de programma instructies.
Do not engage any gears.
Verify the speed of the transmission input shaft in the data list. The speed of the transmission input shaft should remain at 0 rpm for about 30 seconds when the neutral gear is angaged.
De functie is uitgevoerd.
Werkt de functie niet, controleer dan de testvoorwaarden en repareer eventuele defecten.