Kalibratie koppeling, transmissie en ingrijppunt

Met deze functie kalibreert u de positiesensors van koppeling en transmissie en u kunt het ingrijppunt van de koppeling bepalen.
De kalibratie kan op twee manieren:
  1. "Koppeling, transmissie en ingrijppunt zonder vervanging koppeling".
  2. "Koppeling, transmissie en ingrijppunt met vervanging koppeling".
The calibration is performed in three steps, where the results of the calibration are presented together with the current calibration values for each component. The current calibration value must be within the minimum and maximum values which also are presented. If the current calibration value is not within the minimum and maximum, a fault code may occur on the gearbox and the calibration must be performed again. At correctly performed calibration, the fault codes will remain inactive.
Opmerking:
The engine must be turned off until the prompt to start the engine is shown.
Test condities:
Procedure:
  1. Kies welke kalibratie u wilt uitvoeren.
  2. Een dialoogvenster toont de testvoorwaarden. Controleer ze.
  3. Calibrations of the clutch and gearbox are performed.
  4. Calibration of bite point is performed, start the engine when requested.
  5. A dialogue box with the results of the calibrations are presented.