This function is used to program the clutch hydraulic system and must be performed after work on the clutch hydraulics.
Megjegyzés:
Make sure that the hydraulic clutch is fully bleed before performing this function.
Próbafeltételek:
Gyújtás ON, motor OFF – a motor beindul az eljárás során.
Parkoló fék be legyen húzva.
Sebességváltó semleges állásban.
Bleeding of the clutch has been performed.
Eljárás:
Indítsa el a funkciót és kövesse a programban található utasításokat.
Do not engage any gears.
Verify the speed of the transmission input shaft in the data list. The speed of the transmission input shaft should remain at 0 rpm for about 30 seconds when the neutral gear is angaged.
A funkció végrehajtódott.
Ha a funkció végrehajtása sikertelen, ellenőrizze a próbafeltételeket és javítsa ki az összes hibát.