Καλιμπράρισμα της κάμερας πολλαπλών λειτουργιών
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Αυτή η λειτουργία χρησιμοποιείται για να καλιμπράρετε την κάμερα πολλαπλών λειτουργιών στο παρμπρίζ.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
Μετά την αλλαγή του παρμπρίζ.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Αν η κάμερα πολλαπλών λειτουργιών δεν καλιμπραριστεί, ένα προειδοποιητικό μήνυμα θα εμφανιστεί στον πίνακα οργάνων.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Τοποθετήστε το αυτοκίνητο σε ίσιο και επίπεδο δάπεδο.
Παρμπρίζ καθαρό και χωρίς ζημιές στην περιοχή της οπτικής μονάδας.
Το οπτικό πεδίο της κάμερας πρέπει να είναι ελεύθερο.
Ελάχιστη τάση μπαταρίας 12 V.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Ξεκινήστε την λειτουργία όταν οι συνθήκες δοκιμής έχουν εκπληρωθεί.
Το καλιμπράρισμα εκτελείται και το αποτέλεσμα παρουσιάζεται.
Αν η λειτουργία αποτύχει, ελέγξτε τις συνθήκες ελέγχου και επιδιορθώστε οποιοδήποτε σφάλματα.