Monitoimikameran kalibrointi
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Tällä toiminnolla kalibroidaan tuulilasin monitoimikamera.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
Tuulilasin vaihtamisen jälkeen.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Jos monitoimikameraa ei kalibroida, mittaristossa näytetään varoitusviesti.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Auton on oltava tasaisella ja vaakasuoralla pinnalla.
Tuulilasi on puhdas ja ehjä optiikkayksikön alueelta.
Kameran kuva-alueella ei saa olla mitään.
Akun jännite on yli 12 V.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Käynnistä toiminto, kun testausolosuhde-ehdot täyttyvät.
Kalibrointi on tehty ja tulokset näytetään.
Jos toiminto epäonnistuu, tarkista testausolosuhteet ja korjaa mahdolliset viat.