Setting the forward sensing camera
This function must be performed when:
The control unit has been replaced.
When a fault code concerning the forward sensing camera has been registered.
After changing the windshield.
The vehicle needs to be started and driven during the function. Appropriate speed is 65 - 110 km/h.
Drive on a road with good markings (eg highway). Driving distance approx. 10 - 30 km, time approx. 10 - 30 min.
After driving, do not turn off the engine until you are instructed to do this.
Entering the wheel housing heights are done in mm. To convert inch to mm please multiply with 25,4.
No fault codes in the system, except for those who concerns the setting.
Make sure that the windshield is clean.
Note the height from the ground to the wheel house on all the wheels.
Enter the distance from the ground to the wheel housing on each wheel.
Start the engine. Do not start driving until the calibration status is shown.
Drive on a road with good markings in about 65 - 110 km/h. Driving distance approx. 10 - 30 km, time approx. 10 - 30 min.
When the status is 100 %, stop when it is safe and turn off the engine. Press "OK".
Follow the instructions in the program.
The function is done. If the function failed, check test conditions and resolve any error codes.