Multifunktionskamera kalibrering
To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Denne funktion bruges til at kalibrere multifunktionskamera i forruden.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
Efter udskiftning af forrude.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Hvis multifunktionskameraet ikke er kalibreret, vises en advarsel på instrumentet.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Placer bilen på et plant og vandret underlag.
Forrude skal være ren og uden skader i området for optisk enhed.
Kameraets synsvinkel skal være fri.
Batterispænding over 12 volt.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Start fumktionen når testbetingelserne er opfyldt.
Kalibrering udføres og resultatet vises.
Hvis funktionen mislykkes, kontrolleres testforholdene og enhver fejl repareres.