To perform the calibration, a calibration jig from KIA/Hyundai with part no. 09890-3N100 must be used.
Ova se funkcija koristi za kalibraciju kvara kamere na vjetrobranu.
The function may need to be performed after the following repairs or events:
The vehicle has been involved in a crash that has affected the chassis and the body.
Nakon zamjene vjetrobranskog stakla.
The control unit for LDWS system has been replaced.
Work has been done on the camera (LDWS) attachment.
Ako kvar kamere nije kalibriran, pokazat će se poruka upozorenja na instrumentu.
A fault code is stored in the fault memory if the calibration is canceled or not approved.
The picture horizontal center position (X-Position) must be between 123-143.
The picture vertical center position (Y-Position) must be between 179-199.
Postavite vozilo na ravnu podlogu.
Kotači su usmjereni ravno naprijed.
Vjetrobransko staklo je čisto i neoštećeno na mjestu optičke jedinice.
Vidno polje kamere mora biti jasno.
Napon akumulatora je minimalno 12 V.
The room must be well lit to perform the calibration.
When needed, use a bright light to illuminate the calibration jig.
Place the calibration help according to the picture and text below:
Place the calibration jig on the engine hood front edge completely in the center, see picture.
Raise the jig about 40-45 mm, see picture.
The jig must be adjusted so that the control eye is correctly adjusted, see picture.
Pokrenite funkciju kada su ispunjeni testni uvjeti.
Kalibracija je izvedena i rezultat je prikazan.
Ako funkcija ne bude uspješno izvršena, provjerite uvjete testiranja i uklonite sve greške.